3D Printed Epoxy Mixer. Includes Mixer, Two Silicone Mixing Cups and 10 Jumbo Popsicle Sticks. Additional sticks can be found at any craft store or big box department store. Mixing cup holds 100ml, but recommended to mix no more than 60ml at a time. Directions: Pour each part of epoxy into the silicone cup and place i
3D Printed Epoxy Mixer. Includes Mixer, Two Silicone Mixing Cups and 10 Jumbo Popsicle Sticks. Additional sticks can be found at any craft store or big box department store.
Mixing cup holds 100ml, but recommended to mix no more than 60ml at a time.
Directions: Pour each part of epoxy into the silicone cup and place it in the mounted cup to spin. Insert stirring stick into arm and adjust to get the stick against the edge and completely to the bottom of the cup. Tighten the thumb-screws. Spin for 5 minutes. Turn off mixer and release the stirring stick with the thumb-screw and move the arm from over the cup, leaving the stick in the cup. Remove the cup from the mixer and give it a little 20-30 second stir, scraping the sides, and you are good to go!
Products – Bama Cups
MAGNETIC Tumbler Turner for Epoxy Cups
Add On's and Extras – Bama Cups
Stapler Turner Adapter for Basics and Pen Gear Staplers
The Bama Sand-A-Rama Sanding Insert – Bama Cups
NEW PRODUCTS! – Page 2 – Bama Cups
The Perfect Painter – Bama Cups
Products – Bama Cups
MAS 4-Sided Trowel, The four-sided notched trowel is great to use for preparing surfaces for adhering with filled epoxy pastes. Create a ridge epoxy
Epoxy Mixing & Application
Add On's and Extras – Bama Cups