Extruder keeps slicing the filament. This print has a ton of retraction. Should I just lower the retraction rate significantly or is there a way to loosen the group between the extruder

3D Printer Retraction Speed – Simply Explained

A Guide to Understanding the Tolerances of Your 3D Printer

Any idea why the toolhead moves to the front left on a filament change? (AMS) : r/BambuLab

10 Advanced 3D Slicer Settings That Will Save Your Prints

Cura retraction settings explained

Does filament tend to be worse towards the end of the spool? : r/3Dprinting

3D Printer Stringing: 5 Simple Solutions

Never Have Filament Grinding Again - Ultimaker - Tutorial Australia

Stringing or Oozing Simplify3D Software