The Complete Online Guide to Knifemaking, CHOLE and JIMPING – Berg Knifemaking

Chole Notch and Jimping Before heat treating, it’s important to add any jimping or a choil notches. Jimping is a series of half holes on the spine of the blade. They act as a thumb rest and provide extra grip to prevent the blade from sliding. A Choil Notch acts as a starting point for the bevel of the blade. In either

A Beginner's Guide to Knife Making: A Simple Step by

DIY Knife Making how-to video tutorials

All Products – Berg Knifemaking

Introduction to Knife Making book – Berg Knifemaking

All Products – Berg Knifemaking

Berg Knife Making CUSTOMER TILT TABLE TESTIMONIALS – Berg Knifemaking

Making a knife the complete build by Berg Knife Making

A Beginner's Guide to Knife Making: A Simple Step by

Introduction to Knife Making book – Berg Knifemaking